Digital Networks MultiSwitch 948TXG Especificaciones descargar pdf (Pagina 30)

Removing the Card

2-6 Installing Modular Media Interface Cards

Removing the Card

To remove a card from the module (Figure 2-3), complete the following steps:

Step Action

1 Attach one end of an antistatic wrist strap to your wrist and clip the other

end to the chassis ground (for example, a screw on the side of the

chassis).

CAUTION: Static electricity can damage modules and electronic

components. DIGITAL recommends using a grounded antistatic wrist

strap and a grounded work surface when handling any modules.

2 Disconnect all cables from the card. Refer to the card’s documentation

for cable removal information.

3 Use a Phillips-head screwdriver to loosen the two captive screws that

hold the card in place.

4 Grasp the captive screws and disconnect the card from the host module

by pulling on the screws.

5 Gently slide the card out of the slot.

6 Replace the dust caps on the card, if necessary.

7 Place the card into a static-proof bag.

8 If the slot is to be unused, reinstall the slot cover.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 99 100

Sin comentarios

Digital Networks MultiSwitch 948TXG Especificaciones Pagina 30