Digital Networks MultiSwitch 948TXG Especificaciones descargar pdf (Pagina 66)

Assigning an IP Address

6-2 Configuring the Module in a DIGITAL MultiSwitch 900

Assigning an IP Address

After installing the module in a DIGITAL MultiSwitch 900, connecting the cables, and

assigning an IP address, you need to configure the module. Do this using one of the

following methods:

• A Telnet session to access the command line interface

• Through the command line interface, which is accessed through a terminal

connected to the setup port on the DIGITAL MultiSwitch 900

• Through clearVISN MultiChassis Manager

To perform a Telnet session, you must assign an IP address. To do this, complete the

following steps:

Step Action

1 Install the module into a slot on the DIGITAL MultiSwitch 900.

2 Redirect the DIGITAL MultiSwitch 900 Chassis Manager setup port to

the VNswitch 900FX slot.

3 Select the IP Configuration option from the menu.

4 Set the in-band IP address.

5 Set the default gateway, if necessary.

6 Return to the VNswitch 900FX INSTALLATION MENU and select

[2] Restart with Current Settings.

7 Open a Telnet session into the module from the management station for

further configuration. The system displays copyright statements and the

following prompt:

After the system prompt (*) appears, refer to the DIGITAL VNswitch

900 Series Switch Management for further configuration information.

MOS Operator Control

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 99 100

Sin comentarios

Digital Networks MultiSwitch 948TXG Especificaciones Pagina 66